Tempered Steels

Features GRADES GRADES
Size Range (mm) Diameter-width 270-750 250-650 500-1000 41Cr4 (SAE 5140)41CrS4 34CrNiMo6 (SAE 4340)
Size Range (mm) Thickness 250-650 50-100 42CrMo4 (SAE 4140) 42CrMoS4 34CrMo4 (SAE 4135)
Length (m) 4,5 – 8 C45 (SAE 1045) 25CrMo4 (SAE 4130)
Production Norm EN 10250 EN 10250 EN 10250 50CrM4 (SAE 4150)
EN 10221 Surface Crack Test Cannot be done Cannot be done Cannot be done 34Cr4 (SAE 5132)
EN 10308 Ultrasonic Crack Test Makes Cannot be done Makes Makes 37Cr4 (SAE 5135)
C22 (SAE 1020)
C35 (SAE 1035)
C60 (SAE 1060)
  • Blue: Available in our Regular Stocks
  • Navy Blue: Made to Order
  • Grey: Cannot be produced
Category: Product ID: 2065

Description

Tempered Steels

Tempered steels, are non-alloy and alloy machine manufacturing steels the chemical compositions of which are suitable for hardening especially due to carbon amount and show high toughness at a certain tensile strength at the end of the tempering process.

In addition to its hardenability properties, high strength and ductility are also desired in tempered steels. In order to obtain a sufficient level of hardness, tempered steels contain relatively high carbon to others. Since the hardness depth is the most important criterion for thick-sectioned parts, these parts are made of alloyed tempered steels.

Tempered steels can be hardened by flame and induction, or they can be hardened by flame and induction after breeding. In the selection of the material to be heat treated in this way, besides the chemical composition, the hardness value to be obtained on the surface and the hardening depth are taken into account. While the hardness depth in unalloyed steels can be 3-4 mm. In alloy steels, this depth reaches 10-12 mm. In addition, it is more suitable to use high carbon-low manganese Cf quality steels, as they will create a high manganese cracking hazard during induction hardening. In addition, the reduction of the risk of cracking is closely related to the small grain structure of the material.

The tempering process is described as a combination of first a hardening and then damascening, after which the high toughness property will ultimately be imparted to the steel part. Because of the superior mechanical properties that tempered steels gain at the end of the tempering process, they are used in a wide range of areas, such as manufacturing various machine and engine parts, forged parts, various bolts, nuts and studs, crankshafts, axles, control and drive parts, piston rods, various shafts, threads. For this reason, tempered steels are the highest type of steel produced and used after construction and unalloyed steels.

In the selection of tempered steels, part sizes and strength values are at the forefront. Unalloyed tempered steels can only be efficient in small cross-sectional parts. For parts with thick sections, the homogeneity of the hardness distribution depends on the alloying of the steel. Changes of hardness distribution according to material alloys can be observed with jominy test results. In simple terms, the Jominy test refers to the hardening values at distances to the cooled end by cooling only one end of a rod-shaped material heated to the hardening temperature.

Reviews

There are no reviews yet.

Be the first to review “Tempered Steels”

Your email address will not be published. Required fields are marked *